hoangtuan_neu
Active Member
Link tải phim
http://gator884.hostgator.com/~xtreamer/Xtreamer_2.3.1.zip
[DOWNLOAD]http://gator884.hostgator.com/~xtreamer/Xtreamer_2.3.1.zip[/DOWNLOAD]
Hướng dẫn cài đặt:
1. Tải Firmware về ở link bên trên bài viết.
2. Lưu vào máy tính và giải nén file.
3. Chép file xtr vào USB (định dạng FAT32) và kết nối vào Xtreamer qua cổng USB.
3. Bật Xtreamer của các bác lên và vào mục SETTINGS -> SYSTEM
4. Tìm chọn mục FIRMWARE UPGRADE
5. Nhấn OK và chỉ đến đường dẫn chứa file firmware trong USB.
PLEASE NOTE: We do not recommend to upgrade the firmware via your network shared folders, as a loss in connection to the network could cause a break in the firmware upgrade process.
7. Once you have located the file, highlight the file and press ENTER on your remote to begin the upgrade process.
8. The Xtreamer will reboot and the process will be done in matter of few minutes. Once done the Xtreamer will reboot itself.
9. Sau khi quá trình nâng cấp firmware kết thúc thành công, các bác nhớ RESTORE DEFAULT lại trong mục SETTINGS
** CAUTION: DO NOT POWER-OFF THE XTREAMER DURING THE FIRMWARE UPGRADE PROCESS **
Release Note Xtreamer ver 2.3.1
Bug fixes:
1. System crash during Flac/Ogg/Wav file playback. Fixed.
2. System crash during playback or navigation in the “Internet” section with an internal HDD formatted by another formatting tool and not by Xtreamer. Fixed
Emergency Firmware Procedure
[DOWNLOAD]http://gator884.hostgator.com/~xtreamer/Emergency231.zip[/DOWNLOAD]
Link tải phimhttp://gator884.hostgator.com/~xtreamer/Emergency231.zip
Before starting the procedure of emergency recovery - Please make sure you are using the AV RCA cables and not HDMI. Some TV HDCP protocols may cause problem to show the procedure on TV.
(1) Download the Xtreamer Emergency file
(2) Extract the file install.img
(3) Format a USB stick FAT32 and copy the “install.img” file to the root.
(4) Disconnect all the cables, remove WIFI antenna and any other USB storage devices. Take the unit out of the electricty power on the wall for 30 minutes. Plug the power in again.
(5) In Remote control, press “Home”(release button) -> “3”(release button) -> “Power”(release button). Press the buttons with a 1 sec pause.
Any other sequence will fail and nothing will happen as the call for this procedure is initiated by HOME button pressed first...
If the firmware is not in the root of the USB the process will fail as the process seek the .img in the USB root.
Process Emergency upgrade should be visible on the screen if done correct.
Please note : After “intro” screen, if system boots without further update procedure, re-try emergency firmware update while powering-off the unit. It means you did not do it in the correct way. PRESS the HOME first and after 3 and after POWER while the unit is OFF.
It might be necessary to run the procedure several times. If you are not successful you may need to use another USB stick.